Once the brake system has been tested and determined safe to operate the vehicle, follow these steps for the bedding of all new pad materials and rotors. These procedures should …

Semi-Rigid Aluminium SubFrame Spacers
Each spacer is labelled with its position on the subframe. You should have: 4x Bottom 2x Front Up 2x Rear Up You will need to remove the OEM steel spacer …

324mm Rotor Caliper Adapters (R33 GTS-T Caliper)
To begin, determine the left and right-hand side adapters. They are marked as follows:324R33_L or 324R33_R Remove your original Rotor and Caliper and then remove the backing plate or slice …

326mm Front Brake Package (Subaru BRZ ZC6, Toyota 86 ZN6)
Please see the below video on how to install this brake kit. NOTE:If you have a Subaru BRZ 2022 model with Aluminium knuckles, you will need to die-grind the brake …

Brake Master Cylinder Stopper (Subaru BRZ ZC6, Toyota 86 ZN6)
Attached the knurled spacer using the M8x35mm bolt with an M8 lock nut to the HFM.Parts Brake Master Cylinder (BMC) Stopper. Remove the grommets in the RH strut tower. Install …

354mm Front Two Piece Brake Upgrade Kit (R33 GTR)
Check out our installation video below for step-by-step instructions, hints, tips, and tricks to achieve a perfect install. Please Note: There is an error in this video, the kit only …

340mm Rotor Caliper Adapter
Remove the Caliper and rotor from their original position. You may need to peel back or remove the outer edges of the backing plate.Make sure to install the HFM.Parts Caliper …

337mm Rotor Caliper Adaptor
Remove Caliper and rotor from the original position. You may need to peel back or remove the outer edges of the backing plate. Make sure to install the Caliper Adapter …

324mm Rotor Caliper Adaptor Bracket (WIL-NISS324)
This kit is for use with Wilwood Caliper P/N 120-11573. Remove your existing caliper, rotor and brake line. You will also need to remove the backing plate in order to …

324mm Rotor Caliper Adaptors (S13, S14, S15, R32 GTS-T)
Remove Caliper and rotor from the original position. You may need to peel back or remove the outer edges of the backing plate. Make sure to install the Caliper Adapter …