BullNose Extended Wheel Studs for 86 & BRZ
Suits: Toyota 86 ZN6, Subaru BRZ ZC6 (front and rear hubs)
More thread for your wheel nuts when you run spacers. The bullnose tip locates the nut and helps stop cross-threading.
- 60mm long, 11mm longer than the factory 49mm stud
- M12 x 1.25mm thread, 14.3mm knurl
- Grade 10.9
- Suits front and rear hubs
$59.95 AUD
Requirements
Why upgrade
Wheel spacers push the wheel out, which leaves less thread for the wheel nuts to grab. These studs are 60mm long, 11mm longer than the factory 49mm stud, so you get that thread back.
The bullnose tip locates the nut before the threads meet. Wheel changes are quicker and cross-threading is much less likely.
Specifications
| Thread | M12 x 1.25mm |
|---|---|
| Total length | 60mm (factory stud 49mm) |
| Knurl width | 14.3mm |
| Grade | 10.9 |
| Tip | Bullnose |
| Position | Front and rear hubs |
| Sold as | Set |
Fitting
The same stud suits the front and rear hubs. Fit them in place of the factory studs, then torque your wheel nuts to the factory spec.
We recommend installation by a licensed mechanic.
Pairs with
Specifications
M12x1.25mm
Knurl 14.3mm
10.9 Grade
Total Length 60mm
*Suits both front and rear hubs.
What's Included
-
1× Set of BullNose extended wheel studs, M12 x 1.25 x 60mm
Customer Installs
Will it fit your car?
Find your car in the list below and add it to your garage. Every part page then checks it for you.
Our Story
We weren't always HFM.Parts; we were Holford Motors. Our brand's identity was forged not in an office, but on the local circuits in the high-stress world of competitive drifting. Our ultimate testbed was our Nissan S14 Drift car, driven by champion Luke Fink. Pushing that car to its limits exposed a crucial truth: achieving genuine, repeatable performance meant relying on components that simply weren't available affordably on the market.
The HFM.Parts brand was born
We made the commitment to design and manufacture the uncompromising, high-quality performance parts that we, as competitive racers, demanded ourselves. Every component you see is a solution conceived, tested, and proven by us. When you choose HFM.Parts, you are investing in components engineered by racers, for racers, ensuring your vehicle delivers its maximum performance potential.
Modifying vehicles is a specialist task and requires the knowledge and experience of competent
individuals to
be conducted safely.
We recommend this product be installed by a competent person. Instructions are given with every
order
where
available, however, If you would like a copy prior to ordering, you're welcome to contact us
Based on 1 verified reviews