To begin, determine the left and right-hand side adapters. They are marked as follows:
R34324-R or R34324-L
In the bolt kit, you will have:
2x M14 x 1.5 x 30mm Hex Head
2x M14 x 1.5 x 30mm Cap Head
4x M14 x 1.5 x 45mm Hex Head
6x M14 x 28 x 2.5mm Washers
Special Notes:
Make sure to use a good quality thread sealant on all bolts, such as Loctite 262.
Torque Settings are 60-70ft lbs or 81-95Nm
You will need to “test fit” the caliper without the rotor, and tighten the bolts by hand. You will notice that the caliper will bind with the knuckle and create small indentations/marks on the caliper (as seen in the image above). Remove the caliper as these marks indicate where you will need to linish to clear the knuckle and have the correct fitment. (Above: indentations to be linished, Below: after linishing)
The below brake line bracket cannot be used with this brake kit; please remove and discard the bracket and put one of the M8 bolts back into place, as indicated by the white circle below.
Modifying vehicles is a specialist task and requires the knowledge and experience of competent individuals to be conducted safely. We recommend a competent person install this product.
Helpful Links:
Product Page
Get Help