324mm Front Rotor Caliper Adaptor Brackets (RS34324)

Q. Will this fit my vehicle? A. We have only confirmed fitment for the vehicles mentioned under compatibility. If your vehicle is not listed, then we don't know if it fits. Q. Are there any modifications that need to be done to fit this adaptor? A. Yes, you are required to linish/polish the caliper or knuckle side to avoid binding. Please refer to the installation video/guide for assistance. Q. Will the brake pads cover the entire rotor surface, or will I have “Pad Overhang”? A. There will be ~1-2mm of pad overhang; please refer to the reference photo above. This is because the adaptor works by spacing out your existing calipers, which in turn, the brake pads position will follow, to accommodate the larger rotor. There are no brake pads (that we’re aware of) that will fit within the original caliper and cover more surface area. Q. Can I use these adaptor brackets if I have aftermarket lower control arms? A. When installed properly, this adaptor bracket sits close to the lower control arm. In general, if your car retains the OEM stopping position, there should be no interference while using this adaptor. However, we cannot confirm its fitment with any aftermarket products that can change your steering angle. Q. Do I need to get longer brake lines, or can I use the OEM lines? A. While you can retain your OEM brake lines, they will likely be at full extension. We recommend replacing your OEM brake lines with longer braided brake lines.    

Modifying vehicles is a specialist task and requires the knowledge and experience of competent individuals to be conducted safely.
We recommend this product be installed by a competent person. Instructions are given with every order where available, however, If you would like a copy prior to ordering, you're welcome to contact us: Go to Contact Page