Brake Master Cylinder Stopper (Subaru BRZ ZC6, Toyota 86 ZN6)

1. Attached the knurled spacer using the M8x35mm bolt with an M8 lock nut to the HFM.Parts Brake Master Cylinder (BMC) Stopper.
2. Remove the grommets in the RH strut tower.
3. Install the BMC stopper to the strut using an M6 bolt and Nylock Nut to the hole closest to the BMC.
4. Install an M8 bolt and Nylock Nut to the adjacent hole. Tighten the bolt just enough so you can still adjust the BMC stopper spacer so that it becomes flush with the BMC. (see photo)
5. Once it’s positioned correctly, tighten and torque the bolt to: M6 15-18ft M8 25-30ft.
6. Last of all, tighten the knurled spacer (by hand) against the BMC and then tighten the M8 lock nut. Done!

1.	2.
3.	4.

Haven’t got your hands on one yet?