324mm Rotor Caliper Adaptors (S13, S14, S15, R32 GTS-T)

1. Remove Caliper and rotor from the original position.
2. You may need to peel back or remove the outer edges of the backing plate.
3. Make sure to install the Caliper Adapter to the stub axle first using the bolts supplied.
   It is recommended to use a good thread-type sealant as well.
   *Below picture is for illustrative purposes only.
   

Please Note: There are two types of bolts supplied.
When fitting the adapter to the Stub Axle, use the Cap Head Bolts.
Then when re-installing the Caliper to the Adapter, use the Hex Head Bolts

The adaptor should be installed to the inside of the knuckle, as shown here.

Haven’t got your hands on one yet?